RPM Front & Rear A-Arms For The Associated MT8

From RPM:
RPM Front and Rear A-arms for the Associated MT8 are designed to improve durability over stock A-arms. How did we do it? First, by increasing the amount of material surrounding the inner hinge pins by 7%, then increasing the width of that thicker diameter by nearly 40%! We then increased the amount of material at the outer hinge pins by 28%! We also increased the width there too, by another 9%.

The support beams on our A-arms also got beefier. At their thickest, stock a-arms are roughly 1/2” (12.7mm) thick, but taper down on both ends. That amounts to a loss of nearly 30% of their thickness at the outer hinge pins. Not with RPM! Our A-arms are a full 1/2” (12.7mm) over nearly their entire length! We only taper them slightly at the inner hinge pins (.45” or 11.43mm at their narrowest) to match the maximum size allowable of the inner hinge pin bosses. To compensate for that slight taper, we use four massive support beams instead of two, making RPM MT8 A-arms the toughest alternative to stock available!

All RPM A-arms are molded from our nearly indestructible blend of engineering grade nylons for performance you can trust.

Tech Notes: RPM Associated MT8 A-arms are sold in pairs. Our A-arms replace stock Associated #25911.

#70192 Rear A-arms – Black – $16.95
#70195 Rear A-arms – Blue – $16.95
#70202 Front Lower A-arms – Black – $17.95
#70205 Front Lower A-arms – Blue – $17.95
Visit RPMRCProducts.com
See more posts about RPM