Traxxas Hoss 4X4 VXL 900x250

Locked Up RC OT Shafts For The Vaterra Ascender

Locked Up RC OT Shafts For The Vaterra Ascender

From Locked Up RC:
Locked Up RC is happy to present our solution for those that are looking for a stronger, reasonably priced, replacement rear axle shaft for their Vaterra Ascender.

OT shafts offer several improvements over the stock Ascender shafts:

1. Torsional tensile strength rating of over 160in/lbs*. That is over 33% more than a typical stock shaft, which suffers destruction in the 120in/lb range.
2. Precision milled tangs act as the stop for your shaft (preventing it from going to far into the housing), so no need for the silver spacer which wears out over time.
3. You can run “normal” wheel hexes and pins with the shafts. No more special hexes or set screws needed.

Even with these improvements these are a direct replacement requiring little to no modifications to a stock vehicle.
You can expect a direct slide in fit with stock and most aftermarket lockers.

What’s included:

  • 2x Shafts
  • 2x 4mm nuts
  • 2x 2x10mm HD pins

#0823-asc – $21.99
See more posts about Locked Up RC

Locked Up RC OT Shafts For The Vaterra Ascender

Never miss an issue of RC Car Action!

Subscribe today with a Digital Edition subscription or Print + Digital combo!

Eaglemoss Jeep willys 600x120
Updated: September 6, 2017 — 11:44 AM

Leave a Reply

Your email address will not be published. Required fields are marked *

Air Age Media © 2021
WordPress Image Lightbox