From Locked Up RC:
Locked Up RC is happy to present our solution for those that are looking to bolt non-Vaterra driveshafts to their Vaterra Ascender.
These adapters replace the stock pinion shaft (VTR232072 partial) with one that includes a 5MM shaft output.
This will allow you run different length shafts for wheel base changes OR driveshaft upgrades.
Each adapter has a 2mm pin hole, which can be enlarged for big pins or used with our OT shafts.
These adapters offer a torsional tensile strength rating of over 160in/lbs*.
You can expect a direct slide in fit with stock gears.
Fits front & rear axles.
What’s included:
- 1x Adapter
#0827-asc-pinion – $9.99
Visit LockedUpRC.com
See more posts about Locked Up RC