From Locked Up RC:
This is a Limited Edition with only 60 sets produced.
Our 1.9″ Command bead lock ring replicates the look of the Hutchinson bead lock wheels found on the 1:1 Jeep Mighty FC Concept vehicle.
The center cap of the rings can be removed to access your wheel nut without having to remove the entire ring.
Only 2 center cap screws hold it in place. The remaining 6 screws are just for looks!
Although these rings DO have a center cap, the center cap hardware is NOT included.
For center cap hardware we suggest any of these:
- M2x5 Cap screws
- M2x7 Mag Acorns (may require trimming)
- M2x5 Scale Hex Bolts
Made of high quality aluminum this ring is drilled to match the Axial SCX10 1.9″ bead lock ring mounting pattern and anodized black.
These rings work differently than our other 1.9″ Easy Mount rings, so we list them as a “KIT”.
Fitment will likely require you to make changes:
Your axle shaft may hit the back of the center cap and need trimming.
You may need to run a shorter wheel nut.
Center cap hardware over 5mm may run into AO8 or SLW hardware and need trimming.
If you already have wheels, the easiest solution to all of these issues is to run our 1.9″ Wheel Wideners.
If you need a set of wheels then we suggest our 1.9″ OEV WIDE SLW wheels which have a deeper face (you may still need to trim your axle shaft).
For fitment specifics, please consult this chart:
- 1x 1.9″ Command bead lock ring
- 1x 1.9″ Command bead lock ring center cap
Bead Diameter – 1.9″
Width – 2.25mm (at the bead)
Weight – .6oz
Our Easy Mount® wheel system only uses 6 screws to hold the ring to the wheel, making your life much easier when working with foams and weights. An additional 18 screws thread into the ring and slide into larger holes in our Easy Mount® wheels. We suggest M2x7 (or M2x8) screws to hold the ring on. The remaining 18 screws can be M2x8 or shorter but we do not recommend M2x1 screws for this ring.
No hardware is included to attach these rings to a wheel, but it is available below.