From Tekin:
Randy Pike explains how to adjust the Neutral Width setting on Tekin ESCs and goes over how to use this feature. Neutral Width adjusts the dead band around neutral, lower values tighten up this window and higher values expand it. Sometimes a radio signal can wander and a Neutral Width set too low may keep the ESC from accepting the radio’s neutral as an acceptable signal and prevent it from arming. You’ll see a 3 LED code on the left or right of the LED bar if this happens. See this page for info on ESC codes: https://www.teamtekin.com/eschelp.html
Neutral Width is available in 1-13 steps when using the onboard programming and 0-100 through the HotWire module via PC or mobile device.
Visit TeamTekin.com
See more posts about Tekin