AJS Machine Crawler Stand And SCX10 Hitch V2.0

AJS Machine Crawler Stand And SCX10 Hitch V2.0

Crawler Stand

The AJS Machine Crawler Stand is specifically designed for the Axial SCX10 Trail Truck and AX10 Crawler (May work with other Solid Axle type vehicles). The 4″ Round Cradle supports the center of the vehicle and the adjustable arms support the axles. This allows the springs to be removed without axles dropping. Thumbscrews and slots allow up and down, in and out, and side to side adjustment. Easily drop the vehicle onto the cradle and remove it without having to tighten or remove any clamps or screws.

Features all CNC aluminum, steel, and stainless steel construction. The Cradle spins on a steel pin and a nylon bushing allowing a smooth 360 degrees of rotation. This stand comes with the popular 6” long Post. A thumb screw in the aluminum 360 Post locks the cradle in place for heavy wrenching. Subtract your ground clearance from the post length to get an idea of how high the vehicle will sit. The foundation of the 360 Stand is the 360 Base. Your heaviest R/C will be secure sitting on the ¼ inch thick by 11 inch diameter aluminum base. Add the Tool Tray accessory for the ultimate work stand.

All AJS Machine Stand parts and accessories are interchangeable. The Crawler Cradle is recommended to be used with the 6″ and 8″ Posts.

AJS2014 – MSRP $89.99

SCX10 Hitch V2.0

Updated Design! The new sculpted AJS Machine Trailer Hitch is designed to slip inside the chassis frame of the SCX10. Tough 6061 Aluminum construction. Greatly increases the rigidity of your chassis. Includes all mounting hardware. Designed to clear the rear bumper from the Dingo and the rear tube frame of the Honcho. Has mounting holes for use of a bumper. Receiver features the new “Tail Dragger” design allowing less hang ups and is adjustable in and out. A .125 through hole is provided to mount your choice of ball studs. Dual pin design minimizes reciever slop. Hitch is designed to work with the AJS Machine Off Road Trailer but may work with other manufacturer trailers.

Hitch does not come with ball stud or ball cup/rod end but a few styles are offered in the options section.

  • To connect the hitch to a trailer I recommend the following parts for a starting point. Traxxas 1942 Rod Ends and Hollow balls, Associated 6275 and 6274 or similar parts.
  • Requires front mounting of battery tray in truck.
  • To use all 4 mounting screws you must drill out the smaller holes in the chassis to .125 diameter. Or you can just use the 2 larger holes as shown in pictures.

AJS3001 – MSRP $39.99

Never miss an issue of RC Car Action!

Subscribe today with a Digital Edition subscription or Print + Digital combo!

 

Updated: July 21, 2015 — 4:49 PM
Air Age Media ©